start a car with screwdriver ?

How to Start a Car with a Screwdriver: A Step-by-Step Guide

Introduction

Have you ever found yourself in a situation where your car won’t start and you don’t have access to a key or a jump starter? Don’t worry, you can still start your car with a screwdriver. In this article, we will guide you through the process of starting a car with a screwdriver.

Step 1: Locate the Ignition Switch

The first step is to locate the ignition switch. This is usually located on the steering column, dashboard, or center console. Once you have located the ignition switch, remove the plastic cover that surrounds it.

Step 2: Expose the Wires

After removing the plastic cover, you will see a bundle of wires. You need to expose the wires that connect to the ignition switch. To do this, use a wire stripper to remove the insulation from the wires.

Step 3: Identify the Starter Wire

Once you have exposed the wires, you need to identify the starter wire. This wire is usually red or yellow and connects to the ignition switch. You can use a wiring diagram to help you identify the starter wire.

Step 4: Connect the Screwdriver

Now that you have identified the starter wire, you need to connect the screwdriver to it. Insert the screwdriver into the ignition switch where the starter wire connects. Make sure the screwdriver is touching the metal part of the ignition switch.

Step 5: Turn the Screwdriver

Once the screwdriver is in place, turn it as if you were turning a key. This will send a signal to the starter motor, which will start the engine. If the engine doesn’t start, try turning the screwdriver in the opposite direction.

Conclusion

Starting a car with a screwdriver is not recommended as it can damage the ignition switch and the starter motor. However, in an emergency situation, it can be a lifesaver. Remember to be careful and follow the steps carefully to avoid any accidents.

You are looking : start a car with screwdriver

10 start a car with screwdriver for reference

1.How to start a car with a screwdriver – YouTube

  • Author: How
  • Publish: 19 days ago
  • Rating: 4star(1288 Rating)
  • Highest rating: 3star
  • Lowest rating: 2star
  • Descriptions:
  • More :
  • Source : https://www.youtube.com/watch%3Fv%3D7_Hl5AaeOcE

2.How to Start a Car with a Screwdriver and Hammer (5 Steps, 2 …

  • Author: How
  • Publish: 3 days ago
  • Rating: 1star(1339 Rating)
  • Highest rating: 4star
  • Lowest rating: 1star
  • Descriptions:
  • More :
  • Source : https://toolsweek.com/how-to-start-a-car-with-a-screwdriver-and-hammer/

3.How do you start a car with a screwdriver? – Quora

  • Author: How
  • Publish: 20 days ago
  • Rating: 5star(638 Rating)
  • Highest rating: 5star
  • Lowest rating: 2star
  • Descriptions: Insert a flat-head screwdriver into the key hole and turn in the same direction as you would your key. This will start your car.
  • More : Insert a flat-head screwdriver into the key hole and turn in the same direction as you would your key. This will start your car.
  • Source : https://www.quora.com/How-do-you-start-a-car-with-a-screwdriver

4.How to Start a Car with a Screwdriver – Road Sumo

  • Author: How
  • Publish: 29 days ago
  • Rating: 4star(1508 Rating)
  • Highest rating: 3star
  • Lowest rating: 1star
  • Descriptions: Yes, you can. You can start your car even if you have lost its key. First, you need a flat head screwdriver. Then remove the screws that hold the mechanical …
  • More : Yes, you can. You can start your car even if you have lost its key. First, you need a flat head screwdriver. Then remove the screws that hold the mechanical …
  • Source : https://roadsumo.com/how-to-start-a-car-with-a-screwdriver/

5.How to Start a Chevy Truck with a Screwdriver | Step by Step Guide

  • Author: How
  • Publish: 11 days ago
  • Rating: 1star(568 Rating)
  • Highest rating: 4star
  • Lowest rating: 1star
  • Descriptions: So instead, just insert half a screwdriver. When it is in the on position, turn it clockwise once. You’ll produce a sloppy mess and perhaps damage the strands.
  • More : So instead, just insert half a screwdriver. When it is in the on position, turn it clockwise once. You’ll produce a sloppy mess and perhaps damage the strands.
  • Source : https://automotiveex.com/how-to-start-a-chevy-truck-with-a-screwdriver/

6.How To Start A Car With Bad Start Using Screwdriver – Car Super Care

  • Author: How
  • Publish: 5 days ago
  • Rating: 1star(1107 Rating)
  • Highest rating: 3star
  • Lowest rating: 1star
  • Descriptions: Insert The Screwdriver Into The Keyhole And Turn It In The Direction You Turn Your Key … It is the most crucial part of the whole process! Carefully insert the …
  • More : Insert The Screwdriver Into The Keyhole And Turn It In The Direction You Turn Your Key … It is the most crucial part of the whole process! Carefully insert the …
  • Source : https://carsupercare.com/start-car-with-screwdriver/

7.how to use a screwdriver to start a car? – Deleting Solutions –

  • Author: how
  • Publish: 27 days ago
  • Rating: 4star(829 Rating)
  • Highest rating: 5star
  • Lowest rating: 2star
  • Descriptions: how to use a screwdriver to start a car? · One way is to use the Phillips head screwdriver to unscrew the battery cover. · Another way is to use the flathead …
  • More : how to use a screwdriver to start a car? · One way is to use the Phillips head screwdriver to unscrew the battery cover. · Another way is to use the flathead …
  • Source : https://deletingsolutions.com/how-to-use-a-screwdriver-to-start-a-car/

8.How to Start a Car With a Screwdriver and Hammer | 10 Simple Steps

  • Author: How
  • Publish: 0 days ago
  • Rating: 1star(602 Rating)
  • Highest rating: 5star
  • Lowest rating: 3star
  • Descriptions: Slide the handle of your screwdriver into the slot that appears along the bottom of your car’s dashboard. This will cause your screwdriver to lock into place, …
  • More : Slide the handle of your screwdriver into the slot that appears along the bottom of your car’s dashboard. This will cause your screwdriver to lock into place, …
  • Source : https://diyquickly.com/how-to-start-a-car-with-a-screwdriver-and-hammer/

9.How to Break Ignition Lock with Screwdriver in Seconds? – Revolar

  • Author: How
  • Publish: 5 days ago
  • Rating: 3star(395 Rating)
  • Highest rating: 3star
  • Lowest rating: 1star
  • Descriptions: Place the screwdriver to the keyhole and turn right. By following these easy steps, you can remove ignition lock cylinder without key and start your car …
  • More : Place the screwdriver to the keyhole and turn right. By following these easy steps, you can remove ignition lock cylinder without key and start your car …
  • Source : https://revolar.com/how-to-break-ignition-lock-with-screwdriver/

10.Using A Screwdriver To Start Your Car – Hackaday

  • Author: Using
  • Publish: 11 days ago
  • Rating: 1star(684 Rating)
  • Highest rating: 5star
  • Lowest rating: 3star
  • Descriptions:
  • More :
  • Source : https://hackaday.com/2013/05/02/using-a-screwdriver-to-start-your-car/

With the above information sharing about start a car with screwdriver on official and highly reliable information sites will help you get more information.

Related Posts

Trả lời

Email của bạn sẽ không được hiển thị công khai. Các trường bắt buộc được đánh dấu *